Teac CR-H227I - Manual (Page 23)

23
Listening to iPod 1
Press the iPod button of the remote control
unit (or repeatedly press the SOURCE button)
to select “iPod”.
If no iPod is docked, “Unplugged” appears on the
display.
If an iPod is already docked, playback will start.
Insert the iPod into the Dock of the CR-H227i.
“The iPod is connected” briefly appears on the
display.
The iPod automatically turns on and starts playback
from the iPod’s music list.
< Make sure to use an appropriate Dock adapter (see
“Getting started with iPod” on page 22.
< The iPod battery will be fully recharged when the
iPod is docked and the CR-H227i is connected to
the AC power supply.
< When headphones are plugged into the iPod,
sound comes from both the speakers of the CR-
H227i and the headphones.
< The STOP button (H) of the remote control unit
doesn’t work in iPod mode.
2
1 To start or pause playback
In iPod mode, press the PLAY button (G) to start
playback.
During playback, press the Pause button (J) to
pause playback. Playback stops at the current
position. To resume playback, press the PLAY
button (G) or the Pause button (J).
< Following buttons on the main unit don’t work in
the Click Wheel mode:
PLAY, PAUSE, SKIP
IMPORTANT
Buttons for CD and iPod
To use the following buttons on the remote control
unit in CD mode or in iPod mode, you have to press
the CD button or the iPod button beforehand to
switch the function of the remote control unit from
iPod to CD (or from CD to iPod):
PLAY, PAUSE, SHUFFLE, SKIP, SEARCH,
REPEAT 1/ALL
If the remote control unit doesn’t work, press the
CD button or the iPod button and try again.
(Even when the CD or iPod button is pressed
without pointing at the main unit, the function of
the remote control unit will be switched.)
For instance, to use shuffle function in CD mode,
first press the CD button, and then press the
SHUFFLE button.