Usb copy, Management mode, Typical setup procedure – Thecus Technology 1U4500R User Manual

Page 16: Step 1: network setup

Advertising
background image


16

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as

USB disks and digital cameras to the 1U4500 with a press of a button. To use
USB copy, follow the steps below:

1. Plug your USB device into an available USB port on the Front Panel.

2. In Display Mode, press the Down Button (▼).

3. The LCD will display “USB Copy?

4. Press Enter (

) and the 1U4500 will start copying USB disks connected to

the front USB port.

Management Mode

During setup and configuration, the LCD will be in Management Mode.

To enter into Management Mode, press Enter (

)

and an “Enter Password

prompt will show on the LCD.

At this time, the administrator has to enter the correct LCD password. System will

check whether the correct LCD password has been entered. The default LCD
password is “0000”. If correct password is entered, you will enter into the
Management Mode menu.

Management Mode

Item Description
WAN Setting

IP address and netmask of your WAN ports.

LAN Setting

IP address and netmask of your LAN ports.

Link Agg. Setting

Select Load Balance or Failover.

Change Admin Passwd Change administrator’s password for LCD operation.
Reset to Default

Reset system to factory defaults.

Exit Exit

Management Mode and return to Display Mode.

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your 1U4500 for
use on your network. Setting up the 1U4500 typically follows the five steps

outlined below.

For more on how to use the Web Administration Interface, see Chapter 4:

System Management >

Web Administration Interface

.

Step 1: Network Setup

From the Web Administration Interface, you can configure the network settings of

the 1U4500 for your network. You can access the Network menu from the menu
bar.


For details on how to configure your network settings, refer to Chapter 4:

System Management >

Network Management

.

NOTE

You can also change your LCD password using the Web Administration Interface by

navigating to System > Administrator Password. For more on the Web

Administration Interface, see Chapter 4: System Management.

Advertising
This manual is related to the following products: