TANDBERG 880 MXP - Manual (Page 135)

General Use
121
5.1.8 Screen Settings
Auto Layout
On
If Auto Layout is On the system will change layouts automatically depending on the
number of participants in a call and if you have a dual video stream or not. Please
refer to
Layout for more information.
Off
If Auto Layout is Off there will be no automatic layout changes during a call. All
desired layout changes must be done manually.
Note that when you receive low resolution images (176x144 pixels or less) the screen will
automatically adjust to a smaller view to give optimum quality experience.
Use Screen as Local PC Monitor
Use the Selfview button to switch from local PC display to standard conference layout.
On If Local PC Display is On you will be able to have Local PC displayed both outside
a call and in a call.
Off
If Local PC Display is Off you will not be able to see a Local PC image.
Note that this applies to single monitor systems only.
Please refer to
Local PC Display for more information.
Dual Monitor
TANDBERG systems can be used with both one and two monitors. If you use two monitors, make
sure that Dual Monitor is set to "On".
On Selfview, snapshots and Dual Stream will be displayed on the second monitor.
Off The second monitor shows selfview only.
Picture Layout
The Advanced Picture Layout is related to the Layout button on the remote control and it can be
used at any time to change the screen layout. For wide screen systems POP mode is
recommended. You will get optimized picture layouts for wide screen by pressing the Layout
button on the remote.
Picture in Pressing the Layout button on the remote will result in an extra picture in