TANDBERG 880 MXP - Manual (Page 85)

General Use
71
3.10.5 Picture Control
Focus, Brightness and White balance are set for auto focus, auto brightness and auto white
balance by default. If you need to set focus, brightness and white balance manually, go to Picture
Control in the Camera Control menu.
Focus
Auto Auto focus continuously updates the focus throughout the call. When moving
the camera, the system will use auto focus for 5 seconds to set the right focus
of the new camera position. After 5 seconds auto focus is turned off to prevent
continuous focus adjustments of the camera.
Manual
When Manual is selected, the slide bar is enabled. Use the arrow keys to adjust
the focus. The temporary focus will last until you move the camera again and
auto focus will take effect.
Camera Brightness
Auto
Auto brightness continuously updates the brightness of the camera picture.
Manual When Manual is selected, the slide bar is enabled. Use the arrow keys to manually
adjust the camera brightness. If brightness is set manually, the system will keep
this brightness level also when the camera is moved. When the user zoom or
move the camera and manual brightness is on, the indicator line should say
“Manual Brightness”.
White Balance
Auto Auto white balance continuously updates the white balance.
Manual When Manual is selected, the slide bar is enabled. Use the arrow keys to
manually adjust the white balance. The manual white balance has 10 steps. If
white balance is set manually, the system will keep this white balance also when
the camera is moved. When the user zoom or move the camera and manual
white balance is on, the indicator line should say “Manual White Balance”.