Tangent AMP-50 - Manual (Page 5)

WARNING: IT IS IMPORTANT THAT YOU READ AND OBSERVE BOTH THE INSTRUCTIONS IN THIS MANUAL AND
THE INSTRUCTIONS ON THE UNIT. KEEP THIS MANUAL FOR FUTURE REFERENCE
This unit was designed and manufactured with a view to providing maximum safety for the user. Incorrect use of the unit
may cause electrical shock or fire. The protection devices built into this unit will protect the user if the procedures below
are observed in connection with installation, use and repair. This unit is fully electronic and contains no parts that can be
repaired by the user
DO NOT REMOVE THE CABINET. RISK OF DANGEROUS VOLTAGE. ONLY QUALIFIED TECHNICIANS ARE
ALLOWED TO REPAIR THE UNIT
.
.
.
Heat
Do not place the unit near
sources of heat such as radiators,
heat registers, ovens or other
units that produce heat
.
Water and moisture
The unit must not be placed
close to water, such as bathtub,
wash basin, kitchen sink or
laundry tub, in a damp cellar or
close to a swimming pool, etc
.
Cleaning
Unplug the unit before cleaning.
Do not use liquid detergents and
aerosol cleaning agents. Use a
dry cloth
.
Power cords
Wiring must be organised to
prevent people from stepping on
the cables and to avoid pinching
by objects placed on or beside
them. Take special care around
sockets and plug boxes and
where the power cords leave the
unit
.
Overloading
Make sure that wall sockets,
extension cords and plug
boxes are not overloaded as
this may lead to fire or electrical
shock
.
Read the manual
Upon unpacking the unit,
please read the manual
carefully and observe all the
instructions given
.
Power supply
Only the power supply indicated on the
rating plate must be used for this unit.
If you are not sure which power supply
you have, please contact the distributor
or the local electricity supplier
.
Earthing or polarisation
If the plug cannot be inserted properly into the
socket, or if the plug does not fit, the unit must not
be used in your country
.
IMPORTANT SAFETY INSTRUCTIONS
04
Ventilation
.
The cabinet is provided with slots and
openings to ensure ventilation and reliable
operation and to protect the unit against
overheating. Do not block or cover these
openings. The openings must never be
blocked, for instance by placing the unit on
a bed, a sofa, a carpet or similar surface