Trimble Outdoors AgGPS 252 - Manual (Page 33)

C H A P T E R
4
AgGPS 252 Receiver User Guide 27
Configuring the Receiver
4
In this chapter:
Q AgRemote Home Screen
Q Configuring Differential GPS
Q Configuring the AgGPS 252 Receiver to Operate in RTK Mode
Q Configuring the Communication Ports
Use either the Autopilot interface or the Trimble AgRemote utility to
change configuration settings in the AgGPS 252 receiver. You will need
to configure the receiver if you connect to a third-party device, for
example.
• If a Trimble AgGPS Autopilot system is configured to use an
AgGPS 252 receiver, and the port on the receiver is set to
8-N-1 38.4 K, the Autopilot system automatically configures the
receiver.
• The AgRemote utility is available from the Trimble website
(www.trimble.com). This chapter describes how to use the utility
to perform some common configurations.
Note – OmniSTAR VBS and HP are subscriber services that need to be
activated. For more information, see OmniSTAR, page 29.
Ag252_100B_UserGuide_ENG.book Page 27 Thursday, July 28, 2005 4:06 PM