Trimble Outdoors AgGPS 252 - Manual (Page 38)

4 Configuring the Receiver
3 2 AgGPS 252 Receiver User Guide
To configure Port A:
1. Connect the AgGPS 252 receiver to the computer. Turn on the
receiver and start the AgRemote utility.
2. In AgRemote, select Configuration / Port A Config.
3. Use the menu commands to configure the communication
ports. Ensure that the receiver outputs the correct GPS position
data type for the hardware device or software program that is
connected to the receiver.
To configure Port B:
• Repeat the above steps but in Step 2 select Configuration / Port B
Config.
40.1
Configuring input/output communication
The port input and output settings appear in the first screen. In
Figure 4.2, the port is set to accept TSIP inputs at a baud rate of 115,000
with a parity of 8-Odd-1. The outputs are TSIP, also at a baud rate of
115,000.
Figure 4.2 Communication settings
Ag252_100B_UserGuide_ENG.book Page 32 Thursday, July 28, 2005 4:06 PM