Trimble Outdoors AgGPS 252 - Manual (Page 41)

AgGPS 252 Receiver User Guide 35
Configuring the Receiver 4
NMEA settings
Three screens (NMEA1, NMEA2, and NMEA3) show what NMEA
messages are output from the port. Message types shown in upper case
are being output; message types shown in lower case are not.
For more information about NMEA message types, refer to the
document called NMEA-0183 Messages Guide for AgGPS Receivers on
the Trimble website (www.trimble.com).
Port output rate
This setting can be used to vary the NMEA and TSIP output rate. A
setting of 1 outputs one position each second.
ASAP equals the rate selected on the Filter and Position Rate screen
under the GPS Config menu. A setting of ASAP outputs positions five or
ten times every second. The default ( factory) setting is 1 Hz.
Ag252_100B_UserGuide_ENG.book Page 35 Thursday, July 28, 2005 4:06 PM