Telular SX4e TDMA - Manual (Page 14)

SX4e TDMA 800 • SX4e Tri-Mode 14 Technical Manual
PHONECELL SX4e TECHNICIAN PROGRAMMING COMMANDS
How to Enter the Technician Programming Mode
Use the following access code to enter the Technician Programming mode:
Press: # * 0 * 1 2 3 4 4 3 2 1 #
The access code is 8 digits. If the access code is not 8 digits or does not match the access code,
the Programming mode cannot be entered. This code is pre-programmed during production and
cannot be changed in the field.
If you enter the access code correctly, the dial tone should change to a different, steady
“Programming” tone and the bottom LED indicator on the front of the Phonecell will blink alternately
RED and GREEN to indicate that you’re in the programming mode.
Mobile Identification Number (MIN)
The following key sequence is used to enter the FWT phone number:
Press: # * 1 * <MIN> #
If the MIN phone number value is not 10 digits, it is considered invalid and the FWT will not update
or store this value; the currently stored value will remain.
Access Overload Class (ACCOLC)
The following key sequence is used to enter the ACCOLC:
Press: # * 2 * <ACCOLC> #
If the ACCOLC is not in the range of 0 to 15, it is considered invalid. The factory default is 2.
First Paging Channel
The following key sequence is used to set up the first paging channel:
Press: # * 4 * <paging channel> #
If the paging channel is not in the range of 1 to 1023, it is considered invalid. Channels 800 to 990
are invalid. The factory default channel setting is 333.
Home System Identification (SID)
The following key sequence is used to enter the home SID:
Press: # * 5 * <SID> #
If the SID value is not in the range of 0 to 32,767, it is considered invalid. The factory default is 69.
Dial Tone After Remote On-Hook Option
The following key sequence is used to enter the dial tone after remote on-hook option:
Press: # * 8 * <dial tone option> #
The dial tone value is set to 0 for no tone after a remote on-hook; 1 to enable dial tone after remote
on hook. If the value is neither 0 nor 1, it is considered invalid. The factory default is 1.
IMPORTANT!
The following commands may be used by a trained service technician to change the configuration of
the Phonecell FWT. WARNING: These commands are intended for use by trained service technicians
only. Untrained users could damage the Phonecell, violate local regulations and breach the service
agreement with the cellular provider. For further assistance, please contact your Authorized Telular
Representative.
IMPORTANT!
The Phonecell SX4e is capable of over-the-air activation. Please contact your local cellular serv-
ice provider for more information.