Tascam US-144MKII - Manual (Page 13)

TASCAM US-144MKII
13
Installing the driver for Windows
NOTE
During driver installation, a warning that •
“this software ... has not passed Windows
Logo testing
“ will appear. If this message
appears, click Continue to proceed with
the installation.
During installation, you must connect, •
disconnect and reconnect the unit in
steps 7, 8 and 9. You should complete
each of these installation steps in less
than one minute. Installation may fail if
you take too much time.
Confirm that the unit and the PC are 1
not connected by the USB cable.
Insert the included driver installation
2
CD-ROM into the PC where you will
install it.
Click the “
3 Install Driver” button when
the screen below appears. (If this sreen
does not appear automatically, find
and open the “Autorun2.exe” program
in the “Autorun” folder on the driver
CD-ROM.)
When the language selection screen 4
(below) appears, select the language
you prefer and then click the “OK”
button.
Click the “ 5 Install the Driver” button
when the screen below appears.
Read the contents of the License 6
Agreement, and select “I accept the
agreement” if you agree to the terms.
Next, click the “Install” button to start
installation.
When the screen below appears, use 7
the supplied USB cable to connect the
unit to the PC.
3 – Installation