Tascam US-144MKII - Manual (Page 20)

20
TASCAM US-144MKII
CAUTION
Connecting a dynamic mic with an •
unbalanced connection could damage it
if the PHANTOM switch is ON.
Do not connect or disconnect mics when •
the PHANTOM switch is ON. Doing so
could cause loud noise or damage the
equipment.
Use the PHONES and LINE OUT knobs to •
minimize the volume before turning the
phantom switch ON or OFF. Depending
on the mic, loud noises might be
produced and damage could be caused
to equipment or to people’s hearing.
NOTE
When the PHANTOM switch is ON (and •
the unit's power is ON) the PHANTOM
indicator lights on the top panel.
The pin configuration of the unit's XLR •
connector is:
Pin 1 = Ground
Pin 2 = Hot
Pin 3 = Cold
Guitar
Connect your guitar to the R -channel LINE/
GUITAR IN jack (1/4” phone jack) on the
front panel and set the MIC/LINE-GUITAR
switch on the top pannel to GUITAR .
Sound module/MD/CD etc. (digital
connection)
Connect the digital audio output of these
devices as follows.
Sournd module/
MD/CD or similar
device
DIGITAL OUT
DIGITAL IN
NOTE
This unit’s digital input jack is an RCA pin •
jack.
This unit can output either S/PDIF or •
AES/EBU digital signals. Set the type of
output using the control panel.
Guitar
5 – Connections