Topcom BUTLER 550 - Manual (Page 25)

3 Making a phone call
3.1 Normal dialling
• Press the Line button.
• Enter the desired telephone number.
• Press the Line button, after the conversation, to end
communication.
3.2 Block dialling
• Enter the desired telephone number.
• A wrong entry can be corrected by pressing the C-button.
• Press the Line button. The phone dials the telephone number.
The number is shown in the display and starts flashing.
• Press the Line button again, after the conversation, to end
communication.
3.3 Redial
The 5 last dialled numbers are stored in the memory and can be
redialled by pressing the Redial button.
• Press the Redial button until the desired number is shown in
the display.
• Press the Line button. The phone dials the telephone number.
The number is shown in the display and starts flashing.
• Press the Line button again, after the conversation, to end
communication.
3.4 Memory numbers
If you have programmed memory numbers (see chapter 5.1),
they can be dialled out the following way :
• Press the Memory button.
• Enter the number of the memory location or press the
Memory button repeatedly until the desired number is
displayed.
• Press the Line button. The phone dials the telephone
number. The number is shown in the display and starts
flashing.
• Press the Line button again, after the conversation, to end
communication.
3.5 Receiving a telephone call
When a call comes in and the handset is lying on the base,
you only have to pick up the handset when the function
‘Automatic Reception’ is activated. If not, you have to press
the Line button. Press the Line button again, after the
conversation, to end communication.
If the handset is not lying on the base, you have to press the
Line button to answer an incoming call. Press the Line button
again, after the conversation, to end communication.
3.6 Do-Not-Disturb function
When a call comes in and you do not want to hear the
ringing signal but you only want the call to be shown on the
d i s p l a y, then you have to activate the Do-Not-Disturb function.
Press the Set button, followed by “0” and press the Set
button again.
Incoming calls are no longer audible but the symbol
appears on the display. This function will be deactivated
when you press any key or when the handset is lying on
the base.
46 47