Toshiba B-492L - Manual (Page 57)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.5 Printer Parameter Fine Adjustment
A4- 7
A4.5 Printer Parameter
Fine Adjustment
(Cont.)
While in a Pause condition press and hold the [RESTART] key until
“<0>RESET” appears in the display.
Then, press the
[FEED] key three times, and “<3>ADJUST SET” is
displayed.
Feed Length Fine Adjustment
With this parameter you can fine adjust position of the image on the
media. With “<3>ADJUST SET” displayed, press the
[PAUSE] key.
[FEED]
key: Pressing the [FEED] key once causes a –0.5mm
change, down to –50.0 mm.
[RESTART] key: Pressing the [RESTART] key once causes a +0.5mm
change, up to +50.0 mm.
After completing the fine adjustment, press the
[PAUSE] key.
NOTES:
1. If the [FEED] and
[RESTART] keys are
pressed at the same time in
the parameter setting, the
message returns to
“<3>ADJUST SET”.
2. If holding the [FEED] or
[RESTART] key for 0.5
seconds or longer in the
Printer Parameter Fine
Adjustment, the key will
auto repeat.
3. A changed parameter
becomes enabled by
pressing the
[PAUSE] key
4. Use the [FEED] or the
[RESTART] key to change
to a desired value or
option.
NOTE:
The fine adjustment value
equals the sum of the fine
adjustment values set by the PC
command and this parameter.
The maximum feed length fine
adjustment value is ±50.0mm.
When the addition of values
reaches the maximum, the
value remains unchanged even
if subsequent fine adjustments
are made.
Feed Length Fine Adjustment
(Example)
!$'-867 6(7
)((' $'- PP
[RESTART]
[FEED]
)((' $'-PP
)((' $'- PP
)((' $'-PP
)((' $'- PP
)((' $'-PP
!5(6(7