Toshiba B-492L - Manual (Page 58)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.5 Printer Parameter Fine Adjustment
A4- 8
A4.5 Printer Parameter
Fine Adjustment
(Cont.)
Strip Position Fine Adjustment
With this parameter you can fine adjust the dispense position. With
“<3>ADJUST SET” displayed, press the
[PAUSE] key twice.
[FEED] key: Pressing the [FEED] key once causes a –0.5mm
change, down to –50.0 mm.
[RESTART] key: Pressing the [RESTART] key once causes a
+0.5mm change, up to +50.0 mm.
After completing the fine adjustment, press the
[PAUSE] key.
NOTES:
1. In strip issue, the media feed
should be stopped where a 1
mm length of label remains
on the strip plate. If,
however, the feed stop
position is improper due to
too long gap length, etc., a
fine adjustment should be
performed.
2. The fine adjustment value
equals the sum of the fine
adjustment values set by the
PC command and this
parameter.
The maximum strip position
fine adjustment value is
±50.0mm.
When the addition
of the values reaches the
maximum, the value remains
unchanged even if subsequent
fine adjustments are made.
Strip Position Fine Adjustment
(Example)
',6 $'- PP
[RESTART]
[FEED]
',6 $'-PP
',6 $'- PP
',6 $'-PP
',6 $'- PP
',6 $'-PP
Platen
Print Head
Label
Strip Plate
Backing
Paper
-3.0 mm
+3.0 mm
+0.0 mm
Feed
Direction