Toshiba B-492L - Manual (Page 69)

APPENDIX 4 SYSTEM MODE EO1-33032
A4.6 Test Print
A4-19
A4.6 Test Print (Cont.) Characters
While displaying the Characters, press the
[PAUSE] key to start printing
the characters. After printing is completed, the display returns to
“<4>TEST PRINT”.
Pressing the
[PAUSE] key causes the display to show “CHARACTERS”
again. Then, press the [FEED] key.
Barcode
While displaying the Barcode, press the
[PAUSE] key to start printing
the bar codes. After printing is completed, the display returns to
“<4>TEST PRINT”.
Pressing the
[PAUSE] key causes the display to show “BARCODE”
again. Then, press the [FEED] key.
Non-Printing
While displaying the Non-printing, press the
[PAUSE] key to start
issuing a blank page of media. After printing is completed, the display
returns to “<4>TEST PRINT”.
Pressing the
[PAUSE] key causes the display to show “NON-
PRINTING” again. Then, press the [FEED] key.
Factory Test
While displaying the Factory test, press the
[PAUSE] key to start
printing the factory test pattern. After printing is completed, the display
returns to “<4>TEST PRINT”.
Pressing the [PAUSE] key causes the display to indicate “FACTORY
TEST” again. Then, press the [FEED] key.
&+$5$&7(56
%$5&2'(
12135,17,1*
NOTE:
The Non-Printing function
looks like a media feed.
NOTES:
•
Factory test print conditions:
One paper feed, Slant lines (3
dots), Bar codes, Characters,
Item count: 5 pcs. each, Print
speed: 5”/sec., Sensor type:
Black or Feed gap sensor
Ribbon type: Transparent
•
When the feed gap sensor is
selected, a gap length is 3
mm.
Print method: Thermal
transfer, Issue mode: Batch
printing, Label length: 76
mm, Print tone fine
adjustment.
)$&725< 7(67
Print Sample of Characters
Print Sample of Barcodes
Print Sample of Non-print