Tascam GA-100CD - Manual (Page 18)

6 – Using the CD trainer
1
TASCAM GA-100CD
1 Press ø at the front of the CD player cover lightly
to open it.
2 Place a CD in the tray and close the cover.
3 Press
¥/π to start playback.
Press ª to stop playback.
Press ¥/π to pause playback.
Use µ(∆) and ≤(˚) to skip between tracks
and search through them. Press briefly to skip to
another track or press and hold to search a track.
NOTE
Opening the cover stops playback.
Playing CDs
Follow these procedures to set the tempo.
1 Press and hold TEMPO . TMP appears and the
tempo setting screen appears.
2 Use , and keys to adjust the tempo.
3 Press TIME/ESC after completing the setting to
return to the time display.
Changing the tempo value from 0 turns tempo control
ON, and playback speed adjusts to the new tempo.
TEMPO appears on the LCD.
The tempo setting amount depends on whether Variable
Speed Audition (VSA) is ON or OFF. (See "Changing
tempo without changing key" on page 19.)
Setting the tempo
When in a time display mode, use the and keys to
adjust the CD playback level sent to the sub-speakers.
The range is from 0 (no volume) to 10. The key
restores the default setting of 5. The value appears on
the LCD moentarily when it is changed.
Adjusting the CD playback volume
Changing the time display mode
Press TIME/ESC to cycle through the three time display
modes to the right.
Elapsed time (no indicator)
Remaining track time (
REMAIN indicator)
Remaining disc time ( T. REMAIN indicator)
•
•
•
Repeat playback of a selected loop
Follow these procedures to repeat playback of a selected
part of a disc (loop playback).
1 Press
LOOP I/O when a CD is playing or paused
to set the loop IN point (starting point). The I-O
indicator on the LCD blinks.
2 Press LOOP I/O again to set the loop ending point
and start loop playback between the IN and OUT
points. The I-O indicator appears on the LCD
during loop playback.
Stopping loop playback
Press LOOP I/O to stop loop playback, resume normal
playback and erase the IN and OUT point settings.
To retain the loop IN and OUT points, press and hold
LOOP I/O when turning loop playback ON and OFF.
All track or single track repeat playback
Repeat playback of the current track or all tracks on the
disc is possible.
1 In the Setup menu, use the
PLAY item to select all
track loop ( ALL ) or single track loop ( SGL ). The
default setting is ALL . (See “Changing settings” on
page 21.)
2 Press and hold LOOP I/O to start all track or
single track loop playback according to the above
PLAY setting.
Press ª to stop playback.
Press and hold LOOP I/O to stop loop playback
and resume normal playback.
NOTE
Pressing LOOP I/O when IN and OUT points are set
will erase these settings.
•
•