Tascam GA-100CD - Manual (Page 21)

8 – Changing settings
TASCAM GA-100CD
1
Use the Setup menu to change GA-100CD settings.
Press and hold TUNER/SETUP to open the Setup
menu. Press TUNER/SETUP again to cycle through the
setting items. Use the and keys to adjust the values
for each item and to restore the default setting.
Press
TIME/ESC to finish making settings and close
the Setup menu.
Settings that can be made and saved:
Playback mode selection
Footswitch function selection
Footswitch polarity setting
Tuner mode selection
Tuner speaker output ON and OFF
Initialize effect bank settings •
•
•
•
•
•
Playback mode selection
Use the PLAY item to select whether all tracks on a disc
( ALL ) are played or only the currently selected track
( SGL ) is played when using the loop playback function.
The default setting is ALL .
Use the FOOT item to set the function of the CD/
EFFECT footswitch.
PLAY/PAUSE : Play and pause the CD
BANK+ : Increase the active bank number by one
BANK– : Decrease the active bank number by one
TUNER ON/OFF : Turn the tuner ON and OFF
You can use a dual footswitch with the CD/EFFECT
footswitch jack. When using a dual footswitch,
BANK+
and BANK- reverse which switch increases and which
decreases the active bank number.
Footswitch settings
Use the TMOD item to set the tuner mode. (See “Using
the tuner” on page 20.)
CHR : chromatic mode (default setting)
GTR : guitar mode
Tuner settings
Use the FXRS item to restore all effects banks to their
factory settings.
NO appears on the LCD when you choose the FXRS
item. Press the or key and YES will appear. Press
and hold the key to restore all effects banks to their
factory settings.
After initialization is complete, DONE appears on the
LCD and the time display reappears.
CAUTION
Initializing effect banks erases all the preset bank
settings that have been made. Use this function
only if you are sure that you want to overwrite these
settings with the factory defaults.
Initializing effect banks
Footswitch polarity setting
Use the POL item, to set the footswitch polarity to
normal ( NOR ) or inverse ( INV ). Use this to match the
footswitch you use. The default setting is NOR .
Tuner speaker output
Use the TOUT item to set whether or not the guitar
signal outputs through the main speaker when the tuner
is turned on. The default setting is
OFF .