Tektronix TekConnect Probe Interface Module 80A03 - Manual (Page 11)

80A03 TekConnect Probe Interface Module Instruction Manual 1
Getting Started
The 80A03 TekConnect Probe Interface Module is an adapter that allows you to
use TekConnect probes with CSA8000 and TDS8000 Series sampling oscillo-
scopes and 80E0X sampling modules. The interface is comprised of an enclosure
that houses a compartment for one 80E0X electrical sampling module and two
TekConnect probe inputs. The interface connects to the sampling oscilloscope
through a permanently attached 1 meter extender cable.
Figure 1: The 80A03 TekConnect Probe Interface Module
The 80A03 TekConnect Probe Interface Module also allows you the flexibility of
using the interface as a general-purpose sampling module extender cable by
simply disconnecting the short semi-rigid cables on the front panel of the
interface and using the sampling module inputs directly.
The TekConnect Probe Interface Module supports probe interface conversion
between CSA8000 and TDS8000 Series sampling oscilloscopes and the
following TekConnect probes.
Supported TekConnect probes Dynamic Range
P7225
P7240
P7260
P7330
P7350
P7350SMA As reported on the probe label
P7380 1.5 V pk-pk (5X), 6 V pk-pk (25X)
1
P7380SMA 1 V pk-pk (2.5X), 5 V pk-pk (12.5X)
1
1
This differs from the probe label. See the probe label for actual limits.