Tektronix TekConnect Probe Interface Module 80A03 - Manual (Page 20)

Getting Started
10 80A03 TekConnect Probe Interface Module Instruction Manual
4. Connect the probe:
a. Attach the P7000 Series probe to the Channel A input of the 80A03
TekConnect Probe Interface Module.
b. Install the probe tip onto the probe tip adapter.
Figure 7: Equipment setup for functional check
5. Set up the channel for test:
a. On the sampling oscilloscope, press the channel button to select the
channel that is connected.
The Channel button lights, the sampling module LED lights, and the
selected channel on the sampling oscilloscope becomes active.
b. Turn the Vertical scale knob and set the sensitivity to display a waveform
similar to the one shown in Figure 7.
c. Turn the Horizontal scale knob to indicate 2 s/div.