Troy-Bilt 772C0767 - Manuel (Page 17)

17
Figure 22
Figure 23
• Position the friction wheel assembly up onto the pin
of the shift rod assembly, and slide the shaft
through the assembly. Reassemble in reverse
order.
Engine
Refer to the separate engine manual packed with your
unit.
Off-Season Storage
WARNING: Never store the machine or
fuel container indoors where there is an open
flame, spark, or pilot light such as on water
heater, furnace, clothes dryer, or other gas
appliance.
If unit is to be stored over 30 days, prepare for storage
as instructed in the separate engine manual packed
with your snow thrower.
• Clean snow thrower thoroughly.
• Lubricate as instructed in the Maintaining Your
Snow Thrower section of this manual.
• Store the snow thrower in a clean, dry area.
NOTE: When storing any type of power equipment in a
poorly ventilated or metal storage shed, care should be
taken to rustproof the equipment, especially springs,
cables and all moving parts.
Track
Hex Bolt and
Cupped Washer
Shift Rod
Assembly
Sprocket
Spacer
Pin
Friction Wheel
Assembly
Shaft
Support
Bracket
Friction Wheel Rubber
Screws
Friction Wheel
Hub
Plates
A
B