Triax DVB 63S - Manual (Page 6)

6
Operation of TRIAX SR50/SR55 via RC65
The standard remote control for TRIAX DVB65S is RC65. This
RC65 has the option to operate the analogue receivers TRIAX
SR50 and SR55. The factory programming of RC65 is to be a sin-
gle mode RC for DVB63S/65S only, ie the button SAT2 has no
function. By pressing "OK" at the same time as pressing "SAT2",
RC65 turns into a dual mode RC.
SAT1: Operation of TRIAX DVB63S/65S
SAT2: Operation of TRIAX SR50/55
RC65 can be re-programmed to a single mode unit by pressing
"OK" at the same time as "SAT1".
Connection
The following indications a b c etc. refer to the drawing on page 5
Mains connection
The receiver must not be connected to the mains until the receiv-
er has been completely connected to the corresponding compo-
nents. This ensures that you do not damage the receiver or other
components.
Outdoor Unit
Connection of one receiver
a.
Connect the LNB-input of the receiver by means of a suita-
ble coaxial cable to your ODU-LNB. Please also note chap-
ter 5 “Installation”.
Connection of an extra receiver to a single reception system
b
If an extra receiver is to be connected to a single reception
system (e.g. analog receiver or ADR-receiver), you can con-
nect the LNB-input of the extra receiver to the LNB-output
of the DVB-receiver by means of a suitable coaxial cable.
To provide the extra receiver with satellite signals,
your DVB-receiver must be in the “Stand By” mode.
If the DVB-receiver is switched on, this will take
over the LNB-control with priority.
S E T- U P A N D C O N N E C T I O N S