TP-Link RX-7-248 - Manual (Page 5)

GROUP/FOLDBACK and GROUP/ECHO MODULES
1. AUX INPUT (Group/Foldback Module) and ECHO IN (Group/Echo Module) are
both balanced (transformer-isolated), with Low, Mid and High-EQ provided for
both types of inputs.
2. ACCESSORY SEND/RECEIVE jacks are located on the rear of the modules for
inserting signal processing devices.
3. Group On/Off pushbutton allows rapid punch-ins and punch-outs for temporary
killing of an output without disturbing the mixed level.
4. Foldback (FB) MASTER and ECHO SEND controls adjust each output's level
individually.
5. Peak indicators turn on the warn the operator when the signal level reaches l0dB
above nominal.
INPUT MODULE
1. Phantom Power ON/OFF switch.
2. TRIM gain control offers extremely convenient operation when used in
conjunction with INPUT LEVEL switch.
3. MID-EQ is peaking equalization, and its center frequency can be set by a
continuously variable frequency control knob.
4. Two foldback control knobs for the 2 foldback busses. One is Pre-fader and the
other is associated with the PRE-POST selector switch for additional effects.
5. Two echo control knobs for the 2 echo busses. One is Post-fader and the other is
associated with the PRE-POST selector switch.
6. Channel ON/OFF pushbutton provides quick connection or disconnection of the
incoming signal to the mixing busses. The associated green LED illuminates when
the channel is connected to the mixing busses.
7. DIRECT OUT delivers a signal taken directly from the input module, bypassing
the pan pot and group assignment switches. This output is provided for direct
routing to a tape recorder track.
8. ACCESSORY SEND/RECEIVE jacks permit inserting a signal processing device
into the signal path, or can be used to re-route the signal in special applications.
9. PEAK indicator LED turns on when the input signal reaches l0dB above nominal,
to warn the operator to adjust the input sensitivity.
Features
— 4 —