Tascam MD-02 - Manual (Page 35)

TASCAM MD-02/MD-02B
35
Troubleshooting
The power does not come on. ª
Is the power plug completely connected?
“Disc Error!” or “Mecha Error!” appears on ª
the display.
The disc might be dirty. Change the disc.
"System Err!" appears on the screen. ª
The MD deck could be malfunctioning. Please contact a
TEAC service center.
The unit cannot play a disc. ª
Is there condensation?
If there is condensation, eject the disc, turn the power OFF
and wait several hours.
There is no sound. ª
Confirm the connections with the audio system. •
Check the volume and the amplifier settings. •
Cannot record to a disc. ª
If the MD is write-protected, slide the write-protection •
tab.
Confirm connections with connected equipment again. •
Adjust the recording level. •
MDs that are only for playback cannot be recorded. •
Load a recordable MD.
If the MD remaining time is insufficient, erase unneces- •
sary tracks or change the MD.
Confirm the audio system settings. •
Even though I changed a setting, it has not ª
been saved.
This unit backs up mode settings every time they are
changed. If the power is turned OFF too quickly after a
setting is made, the setting might not be saved.
I hear noise. ª
Locate the unit far from televisions and other devices with
strong magnets.
11 − Messages & Troubleshooting