Tascam MD-02 - Manual (Page 7)

TASCAM MD-02/MD-02B
7
Intellectual property rights
TASCAM is a registered trademark of TEAC •
Corporation.
US and foreign patents licensed from Dolby •
Laboratories Licensing Corporation.
Other company names, product names and logos in this •
document are the trademarks or registered trademarks
of their respective owners.
Any data, including, but not limited to information,
described herein are intended only as illustrations
of such data and/or information and not as the
specifications for such data and/or information. TEAC
Corporation disclaims any warranty that any use
of such data and/or information shall be free from
infringement of any third party’s intellectual property
rights or other proprietary rights, and further, assumes
no liability of whatsoever nature in the event of any
such infringement, or arising from or connected with or
related to the use of such data and/or information.
This product is designed to help you record and repro-
duce sound works to which you own the copyright, or
where you have obtained permission from the copyright
holder or the rightful licensor. Unless you own the
copyright, or have obtained the appropriate permission
from the copyright holder or the rightful licensor, your
unauthorized recording, reproduction or distribution
thereof may result in severe criminal penalties under
copyright laws and international copyright treaties.
If you are uncertain about your rights, contact your
legal advisor. Under no circumstances will TEAC
Corporation be responsible for the consequences of any
illegal copying performed using the recorder.
Precautions for placement and use
The guaranteed operating temperature range of this •
product is 5º - 35º C (41º- 95º F).
Install this unit so that it is level.
•
In order to promote the emission of heat, do not place •
anything on top of this product.
Do not place this product on top of a powered amplifier •
or other equipment that emits heat.
Beware of condensation
If the unit is moved from a cold to a warm place, or used
immediately after a cold room has been heated or other-
wise exposed to a sudden temperature change, condensa-
tion could occur. Should this happen, leave the unit for one
or two hours before turning the unit on.
Cleaning the unit
Wipe the unit with a soft dry cloth to clean it. Do not
use any benzine, paint thinner, alcohol or other chemical
agents. Doing so could damage the surface of the unit or
cause fading.
Handling of MDs
The MD itself is mounted inside a cartridge. Soiling or
warping of the cartridge could cause malfunction.
To ensure continued enjoyment of the contents of an MD,
please observe the following precautions.
After use, always return an MD to its case. •
Do not open the shutter and touch the disc inside. •
Moreover, forcing the shutter open could break the MD.
Keep discs out of direct sunlight and places of high heat •
and humidity.
Wipe dirt and grime from the cartridge surface with a •
dry cloth.
When applying labels to an MD, apply them correctly •
to the indicated locations. Loose or raised labels could
cause an MD to become stuck in the unit.
Do not layer labels on top of other labels. •
Cartridge
Shutter
About the User Table of Contents (U-TOC)
Recorded tracks on a recordable MD can be edited.
Information about recorded tracks, including their starting
and ending addresses and titles, is recorded in something
called the User Table of Contents (U-TOC). This is
overwritten when the disc is edited.
U-TOC Music data
Order of songs, start/end times are recorded
1 − Introduction