Texas Instruments 60X - Manual (Page 102)

6-18 Field Service
4. Replacement of the top cover is the reverse of Steps 1 through 3.
Figure 6-15 Removing/Replacing the Top Cover
6.5.11 Removing/Replacing the Fan Assembly
6.5.11.1 (60x Series)
To remove and replace the fan assembly, perform the following procedure:
1. Remove the Top Cover Assembly as described in Paragraph 6.5.10.
2. Remove the single screw holding the fan assembly in place and unplug the
fan cable as shown in Figure 6-16.
3. Remove the Fan Assembly.
Unsnap and remove
the top cover
Remove two screws
near display hinge screw
holes
Remove 10 screws
from bottom of unit
(2 circled screws are shorter)
1.
2.
3.
Note: The 65x Series
Notebooks contain 9 screws
(3 are shorter than the rest)