Tricity Bendix DH 086 - Manual (Page 13)

13
1. Check the filters
Ensure they are clean and properly positioned
(see "Maintenance and cleaning").
2. Check that there is rinse aid and
salt
3. Load the dishes
Remove any scraps of food.
Pull the lower basket out and arrange the saucepans,
plates and cutlery in it.
Pull the upper basket out and arrange the plates,
saucers, glasses and cups etc. in it.
Slide the baskets back into the machine.
4. Ensure that the spray arms can
rotate freely.
5. Measure out detergent
Add the required amount of detergent into the
dispenser according to the indications in the "Washing
programmes" chart.
Close the detergent dispenser lid.
6. Close the dishwasher door
7. Set the programme
Turn the programme selector dial clockwise until the
number of the programme you wish to select
corresponds with the programme marker.
8. Start the programme
Depress the On/Off push button.
The "Mains On" indicator light will come on and the
machine will start.
If you wish to interrupt the washing programme at any
time press this button again.
9. At the end of the washing
programme
At the end of the programme the dishwasher will
automatically stop.
The "Mains On" indicator light remains on until the
On/Off push button is depressed.
10. Switch off the dishwasher
Switch off the dishwasher by pressing the On/Off
push button.
Wait 15/20 minutes before opening the
dishwasher’s door; in this way you will avoid
burning yourself removing the dishes and
avoid also the damage of the nearby furniture
caused by the escape of steam.
Open the door.
Empty the lower basket first and then the upper
one; this will avoid water dripping from the upper
basket onto the dishes in the lower one.
When the washing programme has
finished, it is recommended that the
dishwasher is unplugged and the water
tap turned off.
In general it is not advisable to open the
door while the machine is working; if the
door is opened however, a safety device
ensures that the machine stops.
Important!
Care must be taken if the door is opened
during the hot phase or immediately
after a programme has finished, as
steam may escape.
Operating sequence