Maintenance and cleaning, Internal cleaning, Cleaning the central filters – Tricity Bendix DH 086 User Manual

Page 14: Cleaning the large filter, External cleaning, Prolonged periods of non-operation, Frost precautions, Moving the machine

Advertising
background image

14

Internal cleaning

Ensure that the seals around the door, the detergent and
rinse aid dispensers are cleaned regularly with a damp cloth.

We recommend the use of Finish Dishwasher Cleaner
every 3 months or run a 65°C wash without dishes using
detergent. Regular use of Finish Dishwasher Cleaner cleans
inaccessible parts, eliminates unpleasant food odours and
helps prevent the build-up of limescale.

Cleaning the central filters

(After each

wash)
Inspect the central filters (B) and (C) and remove any scraps
of food with a brush, under running water.

Filters (B) and (C) are both removed by lifting up the outer
one (B) (pulling the central funnel upwards); the smaller filter
(C) can be removed by pressing the two tongues (D).

Once cleaned, refit the filters by pressing them down until
they click into place.

Cleaning the large filter

(every week)

Clean the large filter (A) on both sides under running water,
using a brush.

To take it out, remove the spray arm by pressing the two
tongues (E), turn the ring (F) anticlockwise and then slide
the whole part out. Refit the filter following the above
instructions in reverse order.

External cleaning

Clean the external surfaces of the machine and control
panel with a damp soft cloth. If necessary use only neutral
detergents. Never use abrasive products, scouring pads or
solvent (acetone, trichloroethylene etc....).

Prolonged periods of non-operation

If you are not using the machine for any period of time
you are advised to:

1. Unplug the appliance and then turn off the water.

2. Fill the rinse aid dispenser.

3. Leave the door ajar to prevent the formation of any

unpleasant smells.

4. Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the
temperature is below 0°C. If this is unavoidable, empty the
machine, close the appliance door, disconnect the water
inlet pipe and empty it.

Moving the machine

If you have to move the machine (moving house etc....):

1. Unplug it.

2. Turn the water tap off.

3. Remove the water inlet and discharge hoses.

4. Pull the machine out together with the hoses.

Avoid over tilting the machine during transportation.

Maintenance and cleaning

MA13

B

C

D

MA01

F

A

E

MA08

The dishwasher must not be used without
filters.
Incorrect repositioning and fitting of the
filters will produce poor washing results.
Cleaning the filters is vital to ensure correct
operation of the machine.

Advertising