Tally Genicom Tally Mono Laser 9025N - Manual (Page 62)

U SING THE C ONTROL P ANEL 3.21
3
3
Config Netware
You can set this item only when you set
Netware to On. This item lets you
select whether or not you set the frame
type parameter.
If you select Yes, the IPX Frame Type
option appears on the display.
IPX Frame Type
You can select this item only when you
set Config Netware to Yes. This item
lets you select IPX Frame Type.
• Auto:You can set the frame type
automatically.
• EN_8022: Select this value to use the
IEEE 802.2 frame type.
• EN_8023:Select this value to use the
IEEE 802.3 frame type.
• EN_II :Select this value to use the
ETHERNET II frame type.
• EN_SNAP:Select this value to use the
SNAP frame type.
Reset Network
This item reboots the network interface
card.
Default Set
This item restores the factory default of
the network configuration. This setting
will only take effect after you have reset
the printer.
Print Net CFG
This item print a page showing the
network parameters you set.
Item Explanation
Values: Yes, No*
Values:Auto*,EN_8022,EN_8023,EN_II,
EN_SNAP