Thomas & Betts UDAP - Manual (Page 3)

Form RZ-NA I-UDA, Mfg #195673 Rev 5, Page 3
Special Installations
(Aircraft Hangars/
Repair Garages/
Parking Garages)
3. Warranty
4. Uncrating and
Preparation
Installations in aircraft hangars should be in accordance with ANSI/NFPA No. 409
(latest edition), Standard for Aircraft Hangars; in public garages in accordance
with ANSI/NFPA No. 88A (latest edition), Standard for Parking Structures; and
for repair garages in accordance with ANSI/NFPA No. 88B (latest edition), Stan-
dard for Repair Garages. In Canada, installations in aircraft hangars should be in
accordance with the requirements of the enforcing authorities, and in public ga-
rages in accordance with CAN/CGA B149 codes.
If the heater is being installed in the state of California, the installer MUST attach
a warning label on the outside of the access door. The California Warning label is
shipped in the owner’s envelope along with this manual, the warranty form, and
any other paperwork that applies.
If installation is in California, select a location on the heater access panel. Be sure
the surface is clean and dry and adhere the label.
If the heater is being installed in the Commonwealth of Massachusetts, these units
must be installed by a licensed plumber or licensed gas fitter.
Refer to the limited warranty information on the Warranty Card in the "Owner's
Envelope".
Warranty is void if ...
a. Wiring is not in accordance with the diagram furnished with the heater.
b. The unit is installed without proper clearance to combustible materials.
c. A fan model is connected to a duct system or if the air delivery system is
modified.
This unit was test operated and inspected at the factory prior to crating and was in
operating condition. If the heater has incurred any damage in shipment, document
the damage with the transporting agency and contact an authorized Reznor Dis-
tributor. If you are an authorized Distributor, follow the FOB freight policy proce-
dures as published by Thomas & Betts for Reznor products.
Check the rating plate for the gas specifications and electrical characteristics of the
heater to be sure that they are compatible with the gas and electric supplies at the
installation site.
Read this booklet and become familiar with the installation requirements of your
particular heater. If you do not have knowledge of local requirements, check with
the local gas company or any other local agencies who might have requirements
concerning this installation.
Before beginning, make preparations for necessary supplies, tools, and manpower.
If the installation includes optional vertical louvers, downturn nozzle, ceiling mount-
ing bracket, hanger kit, high altitude kit, multiple heater control, and/or stepdown
transformer, install these options before the heater is suspended. Follow the in-
structions included in the option package; option packages are shipped separately.
Other shipped separate items could include a vent/combustion air kit, high tem-
perature tape, a thermostat bracket kit, a thermostat, and/or a thermostat guard. Be
sure all options ordered are at the installation site.
IMPORTANT: Shipping brackets are attached with cabinet screws. When
removing shipping brackets, re-insert ALL screws into the cabinet.
California Warning
Label
Massachusetts
Requirement