Cleaning, Self-clean, Avoid these cleaners – Thermador POD 302 User Manual
Page 35: Self-clean avoid these cleaners, Cleaning and maintenance
English 31
Cleaning and Maintenance
Cleaning
Self-Clean
During Self-Clean, the oven is heated to a very high temperature. Soil is burned off
at this temperature.
ATTENTION: Wipe out excessive spillage before self-cleaning the oven.
ATTENTION: Do not clean parts or accessories in the Self-Clean oven.
To set the Self-Clean mode:
1. Turn the heating mode dial to "CLEAN".
2. Turn the temperature dial to "CLEAN".
3. Set the cleaning time (1:30 to 2:30 hours) using "+" and "-".
Self-Clean starts after a few seconds and the oven is locked. The oven can be
opened again only after the oven has cooled.
To cancel Self-Clean, turn the heating mode dial to "OFF" position.
A moist cloth is the best way to wipe remaining ash from the oven.
Note:
•
For double oven models: while Self-Clean is in progress in one oven, the other
oven must be off.
•
The oven light cannot be turned on during self-cleaning.
•
The special heat-resistant enamel and the polished components in the oven
can become discolored over time. This is normal and does not affect operation.
Under no circumstances should scouring pads or abrasive cleaners be used to
treat discolorations.
Avoid These Cleaners
Do not use commercial oven cleaners such as Easy Off®. They may damage the
oven finish or parts.
Never use scouring pads or abrasive cleaners.