TANDBERG 550MXP - Manual (Page 195)

Peripheral Equipment
185
1 Audio Output

1 output (line level) via RCA connector providing audio from far end in addition to dial
tones. This output is used by the monitor loudspeakers.
Audio output connector specification:
Connector label Audio outputs
Signal type Unbalanced
Connector (codec) Female RCA/phono, sleeve-ground,
centre-signal
Output impedance 680 ohms
Max output level when set
to maximum output level
Max output level when set
to minimum output level 15.3 Vpp
1.15 Vpp
Range, menu adjustable
output gain 22.5 dB (16 steps of 1.5 dB)
Volume control attenuation
(audio out 1) 0 to 21 dB + mute (steps of 1.5 dB)
5.1.3 Network
Ethernet:
1 x Ethernet (RJ-45 Jack) LAN interface (10/100 Mb) up to 768kbps
To connect the system to a LAN, use the Ethernet cable provided by TANDBERG (or a standard
Ethernet cable).
The cable specification is:
1 ------------ 1
2 ------------ 2
3 ------------ 3
6 ------------ 6
If no LAN is available and the codec is connected directly to a computer, use a crossover cable.
The crossover cable specification is:
If such a connection is needed, the system and the PC must use
‘
static
’
TCP/IP settings because
no DHCP server is controlling the small
“
LAN
”
, which has been created between the computer
and the system. When configuring a back-to-back connection between the PC and the system,
make sure both static IP addresses exist on the same subnet.
ISDN BRI Interface:
ISDN I.420 (RJ-45 Jack) Basic Rate Interface S/T (2B+D), 128 kbps per ISDN I/F