TANDBERG 550MXP - Manual (Page 31)

General Use
21
3.2.2 Selfview
The term
“
Selfview
”
means the outgoing image. In a normal call, using main camera, this is the
image of your self. The Selfview button toggles the images between Far End, Selfview and Dual
Video (if any).
How to use Selfview:
1. Outside a call, pressing the Selfview button will switch between the near end video and a
black screen on the main monitor.
2. In a point to point call, press the Selfview button once to switch from far end video to near
end video see a full screen picture of the outgoing video. Press Selfview again to go back
to normal.
3. In a point to point call with a dual video stream, the dual stream is displayed in the big
picture. Press the Selfview button to toggle to the Near End picture, then the Far End
picture, and finally back to the dual stream.
The above behaviour is similar for both single monitor systems and dual monitor systems.
Selfview applies for the main monitor.