Tunturi E30 - Manual (Page 4)

4
O
W
N
E
R
’S
M
A
N
U
A
L
•
E
3
0
By holding on to the seat, incline the equipment
backwards so that it rests on its transportation
wheels. Attach the rear support from below with
four hexagonal socket head screws and washers.
Attach the front support to the frame with four
screws and washers. Restore the equipment to its
upward position so that it rests on the support feet.
pEDALS
The pedals are distinguished by the markings R (=
right) and L (= left) on their shafts. Fasten the right
pedal to the right pedal crank turning clockwise
and the left pedal to the left pedal crank turning
counterclockwise. Fasten the pedal bands first into
the retainerat the device. Thread the band through
the pedal loop and push the band opening into
the projection in the pedal. Fasten the pedal bands
to the pedal outside. Push the band through the
locking buckle and the band locks automatically.
The length of the band can be adjusted with the
locking buckle.
HANDLEBAR
Attach the cable coming from the frame tube to the
connector at the bottom of the handlebar.
Ensure that the joint is securely locked by gently
pulling the wire. Thread the wire carefully inside
the frame tube and push the handlebar support
tube into place inside the frame tube so that the
fastening screws are on the front of the tube.
NOTE! Use the enclosed Allen key to tighten both
fastening screws through the holes in the tube.
Tighten the fastening screws by turning them
counter-clockwise.
CONSOLE
1. Connect the cables from the handlebar to the
corresponding connectors of the console. Insert the
connected cables into the console, but make sure they
are not damaged when the console is attached.
2. Place the console in position at the end of the
handlebar support tube and attach the console
using mounting screws.