Tapco MIX.FX MIX10FXP - Manual (Page 20)

20
32. MONITOR MASTER LEVEL
This knob controls the overall level of the
monitor mix, and affects the monitor meter
(30), monitor send line-level output (9), and
the speaker-level output B (3) if the internal
amplifi er is playing the monitor mix. The level
adjustment occurs before the monitor EQ
(29) in the signal path.
This gives you ultimate control over your
stage monitors. Adjust it carefully, with your
good eye on the monitor meter (30) to
guard against clipping. Check that your
band are happy with the levels. A happy
band makes for a happy you, and you may
even get paid. The control does not affect
the main mix level.
The monitor mix signals are off with
the level fully down, the “U” marking is
unity gain, and fully up provides 12 dB of
additional gain.
33. SERIES 69 EQ
If you are using TAPCO Series 69 passive
speakers such as the wonderful 6912,
6915, and 6925, then press this switch for
enhanced clarity and low-frequency
response.
If you are not using TAPCO speakers,
then press it anyway and listen for an
improvement. The circuit does not affect
the line-level outputs. Only loudspeakers
connected to the rear panel speaker-level
outputs (3) will be affected.
Internal Effects
The internal effects processor is a mono-
in, stereo-out effects processor, with 16
custom presets. It is fed by adjusting the FX
control (18) on each channel.
The output from the processor can be
added to the main mix and/or monitor mix
by adjusting the FX to main (27) and FX to
monitor (31) controls.
Each preset has been carefully hand-
crafted by our Tapwegian engineers for
your enjoyment and listening pleasure. This
processor is also doing the calculations that
hold together the very fabric of the lunch-
time continuum. If your lunchtimes seem to
fl y by, choose a delay preset 11 or higher.
34. PRESET SELECTOR
Rotate this control to select one of the
16 effects. When you stop the rotation,
that preset will be loaded and become
operational. The different presets are
described in loving detail in the table on the
next page.
35. OL LED
This LED illuminates when the effects
processor is being overloaded with too
strong a signal (OL). Turn down the channel
aux send FX level (18) controls if it is.
LED is short for light-emitting-doohicky.
22 23
24
25
26
27
28
29 30
31
32
33
34
35
9 10 11
12
13