Tapco MIX.FX MIX10FXP - Manual (Page 6)

Microphones
Keyboard
6915 Passive Speakers
(plays stereo main mix)
TAPCO J-2500
Power Amplifier
TAPCO Thump-15A Powered Speakers
used as Stage Monitors
Recorder
Amp Mode
switch set to
Stereo Main
Acoustic Guitar
and Mic
Electric
Guitar
DB-1A
DI Box
6918s Passive Subwoofers
Pole Mount
This diagram shows microphones attached to channels 1 to 4, an electric guitar connected via a TAPCO DB-1A
DI box to channel 5, an acoustic guitar and mic to channel 6, and a keyboard attached to channel 7's stereo
inputs. A portable recorder is attached to the stereo tape outputs to record the performance.
TAPCO Thump TH15A powered speakers are connected to the monitor send, and are set up as stage monitors.
The aux mon controls of each channel allow you to create a stage monitor mix that is independent of the main
mix. Use the monitor graphic EQ to adjust the stage monitor EQ as desired.
TAPCO 6915 passive speakers are connected to the speaker-level power output of the powered mixer, and they
play the main stereo mix to your audience. The Series 69 EQ switch is engaged to enhance the performance
with these Series 69 speakers. TAPCO 6918s passive subwoofers are powered by a TAPCO J-2500 power amplifi er,
connected to the main line outputs to reinforce the low end in your system.
6
Hookup Diagrams
Club System