Technicolor - Thomson STUDIO CAMERA LDK 20(S) - Manual (Page 24)

3-2 Technical Manual LDK 20(S) - Studio Camera Replacements
Introduction Printed circuit boards
The instructions given in this section are restricted to
those modules which can be replaced at the first line
level. After a printed circuit board has been replaced it
is sometimes necessary to carry out adjustments to
match the new boards to your camera and so maintain
the performance levels. The relevant adjustment
procedures are referenced in section 4.
The procedures for removing the modules should be
followed in reverse order when remounting the units. To remove a printed circuit board proceed as follows:
a. Open the side cover (see section 2).
b. Swing the black cover
1 of the printed circuit board
open.
c. Pull horizontally on this cover to free the board from
its connector and slide it clear of the camera.
1