Technicolor - Thomson STUDIO CAMERA LDK 20(S) - Manual (Page 28)

4-2 Technical Manual LDK 20(S) - Studio Camera Adjustments
Introduction
This camera is factory tested and adjusted for operational
use. Under normal circumstances, the internal
potentiometers do not need to be adjusted.
If it is discovered that the camera is misaligned, the
following procedures are given as a guide for competent
service personnel, who have a thorough knowledge of
the camera and have the use of calibrated equipment,
to realign the camera.
If no improvement can be achieved or an adjustment is
out of range, please contact your local supplier or the
nearest Thomson Multimedia Broadcast Solutions
Service Centre.
The camera head adjustment procedures are designed
as separate units. Within a numbered procedure do not
change the position of switches or jumpers unless
instructed to do so in the procedure.
These adjustment procedures are for the Camera Head.
The adjustments require the use of a Master Control
Panel in combination with an Operational Control
Panel if possible. The intercom adjustments are given
for a four-wire system.