Targus netlink e340 - Manual (Page 12)

SpectraLink Corporation Setup and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
3.3 Startup Sequence
The Wireless Telephone goes through an initialization sequence at startup that follows
the following pattern:
Icon The icon(s) shown in bold turns off when:
123456789 The Wireless Telephone has located and authenticated and associated with
at least one AP, and is proceeding to bring up higher-layer networking
functions.
12345678 The Wireless Telephone is either configured for Static IP, or if configured for
DHCP the DHCP discovery process has started.
1234567 If DHCP is configured, a DHCP response was received which contains a
good DNS server configuration.
123456 Note: Only valid on non-SRP protocol. Indicates one of the following:
Static IP configuration, or
SVP Server address found in DHCP response, or
SVP Server address found via DNS lookup.
12345 All networking functions are complete (notably, DHCP) and the Wireless
Telephone is proceeding with establishing the SRP link to the SVP Server.
1234 The SRP link is established, all network stack initialization is complete,
proceeding with application-specific initialization.
123 The link between the Wireless Telephone and the PBX is established.
12 The Wireless Telephone has registered to the PBX.
12
Please Enter PIN Requested if PIN had not previously been entered, if PIN has been cleared,
or if MAC address not entered in the DN con-figuration table on the PBX.
The PIN may be up to 18 characters. The first few are a secret number
defined at the PBX, the rest are the extension of this handset. User must
enter a valid PIN number and press the Send softkey. Alternately, the
handset may be configured in the DN configuration table on the PBX.
Note: there is no timeout and the user must reboot if an invalid PIN is
entered.
1 The Wireless Telephone has received a definition string for each of the 14
programmable buttons. If the handset hangs up at this point, there has been
an undetected error in the retrieval process and the handset will need to be
rebooted.
(no icons)
EXT. XXXXX
Initialization is complete. The Wireless Telephone is in standby mode ready
to receive and place calls.
PN: 72-1084-02-D.doc Page 12