True Manufacturing Company TWT-60F - Manual (Page 7)

............ www.truemfg.com ............
INSTALLATION / OPERATION INSTRUCTIONS
True Food Service Equipment, Inc.
5 5
A. Place packing material behind cabinet as a
cushion. Carefully lay the unit on its back to
remove skid.
When lifting unit remember to
leave the cabinet upright for 24 hours before
plugging into power source.
B. Remove skid by unscrewing all base rail anchor
brackets. Place skid to the side.
C. Carefully lift cabinet upright.
D. Applicance tested according to the climate classes 5
and 7 for temperature and relative humidity.
LOCATING
Removing
skid from
bottom of
cabinet.
Thread castor into the underside of
cabinet frame rail. Thread leg into cabinet bottom
frame rail.
The end of the leg is adjustable to
easy leveling.
Use the tool provided to tighten
the castor into place. For leveling, insert the shim between the
castor and frame rail.
1 2 3 4
5
INSTALLATION OF LEGS AND CASTORS
Important Safeguard for installation of leg/castor (Images 1-5 demonstrate procedure)
Securing Castors and Legs
To obtain maximum strength and stability of the unit,
it is important that you make sure each castor is secure.
Legs are hand-tightened securely against the lower rail
assembly. The bearing race on the castor of the top edge
of the leg must make firm contact with the rail.
Unit leveling
Four leveling shims have been provided for leveling
castored units positioned on uneven floors. Shims must
be positioned between rail end and bearing race. TRUE
requires a four shim limit to each individual castor.
A. Turn the bearing race counter-clockwise until the
cabinet is level. Level front to back and side to side.
(diagonally)
B. Install the desired number of shims, making sure the
slot of the shim is in contact with the threaded stem
of the castor.
C. If more than one shim is used, turn the slot at a 90°
angle so they are not in line.
D. Turn the bearing race clockwise to tighten and secure
the castor by tightening the anchoring bolt with a
3/4 inch open-end wrench or the tool provided.
CAUTION
To avoid damage to lower rail assembly, slowly raise unit to
upright position.