True Manufacturing Company TWT-60F - Manual (Page 8)

............ www.truemfg.com ............
True Food Service Equipment, Inc.
6 6
A. Before your new unit is connected to a
power supply, check the incoming voltage with
a voltmeter. If anything less than 100% of the
rated voltage for operation is noted, correct
immediately.
B. All units are equipped with a service cord, and must
be powered at proper operating voltage at all times.
Refer to cabinet data plate for this voltage.
TRUE requires that a sole use circuit be dedicated for the
unit. Failure to do so voids warranty.
WARNING
Compressor warranties are void if compressor burns out
due to low voltage.
WARNING
Power supply cord ground should not be removed!
WARNING
Do not use electrical appliances inside the food storage
compartments of the appliances unless they are of the
type recommended by the manufacturer.
NOTE
To reference wiring diagram - Remove front louvered grill,
wiring diagram is positioned on the inside cabinet wall.
ELECTRICAL INSTRUCTIONS
A. Set unit in its final location. Be sure there is
adequate ventilation in your room. Under
extreme heat conditions, (100°F+, 38°C+), you
may want to install an exhaust fan.
WARNING
Warranty is void if ventilation is insufficient.
B. Proper leveling of your TRUE freezer is critical
to operating success (for non-mobile models).
Effective condensate removal and door
operation will be effected by leveling.
C. The freezer should be leveled from inside the
cabinet. Place a level on the inside floor of the
unit front to back and side to side.
D. Ensure that the drain hose or hoses are
positioned in the pan.
E. Free plug and cord from inside the lower rear of
the freezer (do not plug in).
F. The unit should be placed close enough to the
electrical supply so that extension cords are
never used.
WARNING
Cabinet warranties are void if OEM power cord is tampered
with. TRUE will not warranty any units that are connected to
an extension cord.
LEVELING
INSTALLATION / OPERATION INSTRUCTIONS