TurboChef Technologies TurboChef High h Conveyor 2020 User Manual

Page 26

Advertising
background image

18

TrOUBLeSHOOTING

Issue

Possible Cause(s)

resolution

F2: Low Temp

During Cook

- Oven power interrupted.

- Excessive load.
- Oven is not clean.

- Oven not fully warmed up.

- Defective heater.
- Blower motor not running.

- Low supply voltage.

- Verify wall circuit breaker is on. Reset breaker

and then power oven back on.

- Reduce load.
- Clean the oven following the weekly cleaning

instructions on pages 6-8.

- Press the back/off key until oven returns to the

oven off mode. Re-select the cooking profile

and allow oven to reheat.

- Call customer service.
- Call customer service.
- Call electrician to improve power supply.

F5: CC Over Temp - Blockage of airflow into the

oven.

- Problem with the blower

motors or heater.

- Defective SSR.

- Check for and remove anything that may be

obstructing regular airflow into the oven.

- Call customer service.

- Call customer service.

F6: EC Over Temp - Blockage of airflow into the

electrical compartment.

- Problem with the cooling

fans.

- Check for paper towels or anything that may

be obstructing cool air into the electrical

compartment.

- Call customer service.

F7: RTD Failure

- Damaged or defective oven

components.

- Call customer service.

F8: High Limit

Tripped

- Oven is not clean.

- Clean the oven following the weekly cleaning

instructions on pages 6-8. If problem persists,

call customer service.

F9: Belt Run

Failure

- Too much weight on belt.

- Obstruction blocking belt

rotation.

- Damaged or defective oven

components.

- Overheated conveyor drives

- Ensure oven is in the off state and completely

cooled and belt is completely stopped. If belt is

overloaded, remove product from belt.

- Ensure oven is in the off state and completely

cooled and belt is completely stopped. Look

into oven cavity and remove any obstructions

that are blocking the belt’s rotation.

- Call customer service.

- Ensure the filters are clean and fans are

running. Also ensure ambient temperature is

not excessive (greater than 100°F [38°C]).

Advertising
This manual is related to the following products: