Toastmaster 1750 - Manual (Page 10)

9.
5. Plug blender body into a standard 120V AC electrical outlet.
6. Hold the unit firmly and press the desired high or low speed
control button.
7. When chopping task is complete, release the speed control button
and remove plug from electrical outlet.
8. Carefully remove the chopper drive by pushing down on the
release button.
Using The Large Chopper Container
CAUTION: Use extreme care when handling the double blade knife.
Do not touch the blades with your
fingers. The blades are very sharp and
can cause injury if touched.
1. Select a flat, stable surface for the
chopping operation.
2. Place the large double-blade knife
over the stem in the large chopper
container. Make sure the knife is
running smoothly by pressing down
on and turning the drive shaft. (Use
care to avoid touching the knife
blade).
3. Put the ingredients into the large
chopper container and place the
chopper drive on the large chopper
container.
4. Place the blender body over the
chopper drive and carefully push down until it “clicks” into place.
Gently turn the blender body at the same time if necessary.
5. Plug the blender body into a standard 120V AC electrical outlet.
6. Hold the unit firmly and press the desired high or low speed
control button.
7. When chopping ice, use the large chopper container and the low
speed chopper drive. Add ice cubes to large chopper container. Do
not add water.
Repeatedly press and release the low speed selector
button “I” to create a pulsing action. Continue until the ice cubes
are chopped to desired consistency.
8. When chopping task is complete, release the speed control button
and remove plug from electrical outlet.
9. Carefully remove the chopper drive by pushing down on release
button.
Chopper
Drive
Large
Double-Blade
Knife
Large Chopper
Container
Maximum
Liquid Level
Maximum
Solid Level
Figure 4
TMR_1750&CAN_IB_18-11-04 11/18/04 11:49 PM Page 9