TP-Link TL-WR941N - Manual (Page 26)

TL-WR941N/TL-WR941ND Wireless N Router
- 21 -
4.5 Network
Figure 4-4 the Network menu
There are three submenus under the Network menu (shown in Figure 4-4): LAN, WAN and MAC
Clone. Click any of them, and you will be able to configure the corresponding function.
4.5.1 LAN
Choose menu “Network→LAN”, you can configure the IP parameters of the LAN on the screen
as below.
Figure 4-5 LAN
¾ MAC Address - The physical address of the router, as seen from the LAN. The value can't
be changed.
¾
IP Address - Enter the IP address of your router or reset it in dotted-decimal notation
(factory default: 192.168.1.1).
¾
Subnet Mask - An address code that determines the size of the network. Normally use
255.255.255.0 as the subnet mask.
)
Note:
a. If you change the IP Address of LAN, you must use the new IP Address to login the router.
b. If the new LAN IP Address you set is not in the same subnet,
the IP Address pool of the
DHCP server will change accordingly at the same time，while the Virtual Server and DMZ
Host will not take effect until they are re-configured.
4.5.2 WAN
Choose menu “Network→WAN”, you can configure the IP parameters of the WAN on the screen
below.