Trango Broadband M2400S - Manual (Page 18)

Basic Configuration via Browser Interface
Trango Broadband Wireless — User Manual M2400S Rev A Page 14
2. Set Base ID, or choose default base ID of 0000 (must match the SU).
3. Set AP ID (00-FF HEX).
4. Set IP, Subnet, and Gateway, or leave at default settings. Keep in mind if you change the IP Settings of
the radio you will loose your HTTP session when you save and activate.
5. Choose Active Channel (1-8).
6. Choose Antenna Polarization (H or V) or choose E for an external antenna.
7. Ensure default Opmode is "ON."
8. Save and Activate Settings.
9. If this is the first SU to be added to the SUDB, reboot the AP.
After reboot, the AP will automatically enter its default Opmode, after approximately 40 seconds. At this time it
will begin actively searching for all SUs in its SUDB. Once an active SU is detected, the authentication and
association process will begin.