Trango Broadband M2400S - Manual (Page 45)

Trango Broadband Wireless — User Manual M2400S Rev. A Page 41
Command Radio Description Access
pppoeonly SU Display current PPPoE filter setting ro/rw
pppoeonly <on | off> SU Change PPPoE filter setting
With PPPoE filter set to ON, only PPPoE packets will pass Default:
off – Pass All Packets rw
reboot AP/SU Reboot unit ro/rw
remarks AP/SU Display remarks ro/rw
remarks <str,31 octs> AP/SU Overwrite remarks rw
reset AP/SU Reset radio’s system settings back to factory defaults, then reboot rw
rfrxth AP/SU Display current RF RX Threshold ro/rw
rfrxth <-98..-55> AP/SU Change current RF RX Threshold
default = -98 dBm rw
rssi AP/SU Display current RX RSSI for packets received during a 1s window
Opmode “OFF” only on AP ro/rw
save <mainimage | fpgaimage> <current
chscksum> <new checksum> AP/SU Save new firmware. This command gets new firmware image from
TFTP buffer, verifies checksum and writes to flash memory at main
or FPGA image section.
rw
save sudb AP Save SUDB into flash memory rw
save <systemsetting | ss> AP/SU Save current configuration into flash memory rw
set apid <ap-id> AP Set AP ID, <ap-id> = 1..255 rw
set baseid <base-id, 4 oct> AP/SU Set base station id Base ID = XXXX where X = any alphanumeric
character except “/” rw
set defaultopmode <on | off> AP/SU Set default Opmode to “ON” or “OFF”
Factory set default Opmode is “OFF” rw
set httpport [<port #>] AP/SU Set or display HTTPD port number
port # = 1..65534
default port = 80 rw
set snmpcomm <read | write | trap id# |trap all> AP/SU Set SNMP read or write or trap community string rw
set telnetport [<port #>] AP/SU Specify telnet port, <port #> = 1..65534
Default port = 23 rw
snmpsample <min, 1..60> AP/SU Set SNMP sample period rw
su password <suid | all> <rw | ro> <new
password> <new password> AP Change read/write or read-only password of all or a specific
subscriber rw
su <all | suid> AP Display all or specific SU information in SUBD ro/rw
su info <suid> AP Command issued from the AP to gather information about specific
SUs.
1. Distance
2. RSSI at AP
3. RSSI at SU
4. IP
address
5. Subnet address
6. Gateway address
7. Device ID
8. Hardware version
9. FPGA version
10. FPGA checksum
11. Firmware version
12. Firmware checksum
13. Firmware datecode
14. Broadcast/multicast packet filter on/off
15. Auto scan AP on/off
16. TCP/IP for AP on/off
17. HTTPD on/off
18. TCP/IP service for Ethernet port on/off
19. Default channel and antenna
20. Active channel and antenna
21. TX power
ro/rw