Teka AUTOMATIC DRUM WASHING MACHINE LSE-1200 S - Manual (Page 3)

Remaining time 1 hour and 16 minutes
Remaining time 1 minute
Setting washing temperature at 60
Setting washing without heating process
Setting no Spin process
Setting dehydration revolutions 800r/min
Code for manual selection of weight, when clothes are less than 1kg
Code for manual selection of weight, when clothes are almost full of the roller
Start-up keyboard locking function
Cancel keyboard locking function
Procedure is entirely finished
Failure information: locking door function abnormity
Processing mode: reclose the door, if there is still any alarm, please contact service people
Failure information: draining malfunction
Processing mode: rinse the filter of draining pump, examine whether the drainpipe
is blocked if there is still any alarm, please contact service people.
Failure information: temperature pickup malfuntion
Processing mode: please contact the service people.
Failure information: fuser malfunction (display after procedure operation)
Processing mode: please contact the service people.
Failure information: water intake abnormity
Processing mode: check whether the water hydraulic pressure is too low or water
supply is cut off. Please contact the service people.
Failure information: dehumidification and heating abnormity.
Processing mode: Please contact the service people.
Failure information: superabundant spume in the roller or motor failure
Processing mode: inflow water and vent the spume or please contact the service people.
Failure information: drying temperature sensor malfunction
Processing mode: Please contact the service people.
Failure information: waterlevel sensor malfunction
Processing mode: Please contact the service people.
Failure information: drying waterlevel sensor abnormity
Processing mode: check whether the clothes is dried or not, and whether there is water
in the roller,Dry it again after the dehumidifying process. If there is still any alarm, please
contact the service people.
Failure information: The door is not properly closed after the activation of the procedure
Processing mode: Reclose the door. If there is still any alarm, please contact the service people.
Failure information: when spined, clothes is unevenly distributed
Processing mode: Quiver and scatter the clothes to make it even. If there is still any
alarm, please contact the service people
Codes on Display Screen Part names
Detergent dis-
tribution drawer
Display
Door
Glass
Power cable
Screws for rear
panel
Bolts for transport
Drainage hose
Caution and Warning Symbols
For your safety, any instructions in this manual with this "Warning"
sign shall be strictly followed.
For your safety and to prevent damages to the washing machine,
any instructions in this manual with this "Stop" sign shall be strictly
followed.
This diagram may vary slightly with the layout of the washing machine you have just purchased
due to technical improvements.
Rear panel
Programme selector
Function button
Door handle
Skirting
Control panel
Hose clip
Earth terminal