Teka AUTOMATIC DRUM WASHING MACHINE LSE-1200 S - Manual (Page 9)

5. After the completion of the whole program, this machine provides a short piece
of enjoyable music, reminding you of the finish of the washing process. Just open
the door of the machine to take out your clean clothes.
Other functions
1. Power off memory function: In case there is power breakdown or the plug
accidentally falls out of the outlet when the machine is in operation, this
machine can memorize the running of the program so that it continues with
its work after the resume of power.
2. The machine can memorize the preset condition of precious washing, which
means it can memorize the habit of the user in washing clothes. You can just
press the button "start/pause" to begin washing or re-set the program before
operating.
4. Cancel the program or choose another program as well as other accessional
functions when the machine is in operation (the keyboard-locking function closed)
A. Turn the program knot to the position of turning off, and the program
automatically stops; turn the knot again to choose new program.
B. If some accessional functions need to be chosen when the program is at work,
press the button "start/pause". After choosing the accessional functions press
the same button again.
Note: Refer to the program setting guide for information concerning functions
attachable to different programs.
1. Place the threaded end of the water inlet hose on
the water inlet valve connector. threaded end of
2. Check that the connection is correct by
tightening the threaded end on the connector.
water inlet valve connector
Positioning the drainage hose
· The free end must be at a height of between 80 and 100 cm. The drainage hose must be
fastened on the rear panel with the retaining clip.
· Fix the drainage hose in the correct position with the support supplied.
It is inadvisable to lengthen the hose; if necessary, contact the Service
Centre. The extension must not exceed 250 cm in length (an overlong
extension could cause the water to drain while the washing machine is
still loading). The diameter of the extension hose must be the same as
that of the original drainage hose.
Note: the free end must not be immersed in water. Connect the
drainage hose securely in order to prevent leakage.
· whether the socket is able to support the washing machine’s maximum load (the socket
and the power cable must be able to support a maximum current of no less than 15A).
·
whether the mains voltage conforms to the required value.
· if the power socket to which the washing machine is connected is not the same as the plug,
replace it with a suitable one; alternatively, consult a specialised engineer or the Service
Centre for a suitable socket. The washing machine must be correctly earthed.
·
the supplementary earth cable is not necessary if the power socket is earthed.
· the supplementary earth cable is installed at the top of the rear panel of the washing
machine and earthed if the power supply socket has no earth connection.
Note: do not connect the supplementary earth cable to the water hose or heating pipe.
Connection of power supply
Check the following items before connection to the power supply.
Installation
3. keyboard-locking function
After starting the program, press the buttons "reserve" and "start/pause" at
one time for about 3seconds and the keyboard-locking function is started up.
In this condition, pressing any other function keys or turning any knobs,
resulting in suggestive sound, won't change the program. Press the buttons
"reserve" and "start/pause" at one time again for about 3seconds and the
keyboard-locking function is closed.