Unisar AC401-2P - Manual (Page 14)

TIPS FOR USING YOUR MONITOR
• When the monitor is in use, do not use a crib mobile or other crib accessories that may
produce vibrations. Other sources of vibrations may include fans, washing machines, loud
music, etc. These sources of vibration may interfere with the performance of your Angelcare
®
monitor and the alarm will not sound if it continues to detect any movement other than your
baby’s. Be sure all vibration sources are eliminated before using the monitor.
• You may experience false alarms for several reasons. The most common reason is the
Nursery Unit has not been turned off after you have removed your baby from the crib. Another
reason is the Sensor Pad has not been placed under the mattress properly. Be sure the
Sensor Pad is on a flat, firm surface with the turquoise side facing up. The sensitivity level may
also need to be adjusted. Refer to the Movement Sensitivity Adjustment section on Pg. 12.
• Your monitor can be used in any crib that is stationary and designed to safely hold a baby.
If your crib has a spring or slat base you will need to place a piece of Masonite or plywood
under the Sensor Pad. This support must be at least 13 inches long on all four sides and
1 /
4
inch thick. Only use your Angelcare ® monitor in a stationary sleeping environment such as a
crib where the Sensor Pad can rest on a completely flat, firm surface.
• When unplugging the AC adapter from the Nursery Unit, be sure it is switched to the OFF
position. If it isn’t, the unit will revert to battery mode if batteries are installed.
• You can use rechargeable batteries in the Nursery Unit, however, they will not be recharged
by plugging in the AC adapter. To recharge, remove the batteries and use an external charger.
• IMPORTANT: Only use rechargeable batteries in the Parents’ Units. DO NOT use alkaline
batteries. Using alkaline batteries will damage the Parents’ Units.
UNDERSTANDING THE SYMBOLS
Symbol Name Meaning
Appears when options are being set for
the Nursery Unit.
Appears when no movement is detected.
Flashes when Nursery Unit is paging Parents’ Unit.
Nursery Unit flashes and “ ” is displayed when
Parents’ Unit is on but Nursery Unit is off.
Indicates to which channel the monitor is set.
Indicates temperature of nursery.
Appears when options are being set for the
Parents’ Unit.
Appears when Sound feature is selected.
Flashes when the Parents’ Unit is temporarily
on mute.
Nursery Unit
Nursery Unit and No Channel
Channel
Temperature Display
Parents’ Unit
Sound
- -
14
--
C3
F