Unisar AC401-2P - Manual (Page 6)

Movement Sensitivity Control. The movement sensitivity control is on the back
of the Nursery Unit. The level has been preset to 2.5 (see fig. 6). Do not adjust this
unless you receive false alarms. Refer to the Movement Sensitivity Adjustment
section on Pg. 12. It is extremely important to follow our instructions for setting the
sensitivity level.
Now plug the Sensor Pad cord into the jack on the back of the Nursery Unit marked
“Sensor Pad.” Turn the Nursery Unit on using the switch on the left. The green Power Indicator
will light up.
PARENTS’ UNIT (Receiver) (See figs. 7, 8, 9, and 10)
IMPORTANT: You must use only rechargeable batteries in the Parents’ Unit. DO NOT use
alkaline batteries or you will severely damage the unit. Charge the batteries for 15 hours prior
to first use. Be sure to have the monitor in the OFF position during this period. Only use the
AC adapters included with your monitor. Do not use these adapters with any other equipment.
The Parents’ Unit requires four AAA rechargeable batteries (included). To insert batteries,
remove the battery cover on the back of the unit and insert the batteries matching positive
(+) to positive (+) and negative (-) to negative (-) and replace the battery cover. Insert the AC
adapter into the jack marked “7.5V” on the back of the Charging Base and plug the adapter into
an electrical outlet. Place the Parents’ Unit in the Charging Base.
fig. 6
73
F
fig. 7 fig. 8
Charging
Base
fig. 9 fig. 10
Antenna
LCD
Arrow
Buttons
Menu Button
Select/
Channel Button
Speaker
Power/Mute/
Exit Button
Belt Clip
Battery
Compartment
AC
Adapter Jack
Front Back
Front Back
6