Uniden UBC92XLT - Manual (Page 16)

16
Setting Up Your Scanner
3. Install two batteries in the compartment as
indicated by the polarity symbols (+ and -)
marked inside.
4. Replace the cover.
5. Connect the supplied AC adapter to the
scanner's DC 6V to charge the batteris. (See
“Using AC Power” on page 18.)
Using Non-rechargeable Batteries
You can also use two alkaline batteries to power
your scanner. Before you use alkaline batteries, you
must remove the sticker in the compartment and
move the switch to REG. ALK. BATT position.
Removesticker and
set switch for use of
Alkaline batteries.
UB324 Paper OM reduced size.fm Page 16 Wednesday, February 2, 2005 8:01 PM